Information of the ovserving factory of DORAEMON spoon

• You can see the manufucture of a DORAEMON spoon.
• Open time : Equal to Opent time of the store.（normally、9:00 to 18:00)
• No fee, no reserve.

１）JI-NUKI(Cut the first form of spoon out from stainless steel) ２）ROLL(Widen the part of the spoon) ３）E-OSI(Put a design on the hundle） ４）HAN-KIRI(Cut out the part of a spoon to round form.） ５）TSUBO-OSI(Put the hollow on the part of a spoon） ６）Finish after polishing,coloring etc

☆Sorry, you can`t ovserve the manufuture of a scissors and a kitchen knife in our ovserving factory. But those photos is below.

The manufucture of a kitchen knfie	The manufucture of a scissors